Hauck FixSit Deluxe Instrucciones Para El Uso página 7

ASSEMBLY INSTRUCTIONS AND INSTRUCTIONS FOR USE
1. Put the backrest to the upright position and stretch out the 2 legs apart (fig. 1).
2. Clap the legs onto the table (fig. 2).
3. Press the adjustor on each legs and lift up the stopper (fig. 3).
4. Twist the screw upwards to tighten the stopper until the table chair is tightened onto the table
(fig. 4). Add force onto the seat to test the stability of the seat and the table first before placing
your child in.
5. To release the table chair from the table, loosen the screw of the stopper and press the adjustor
to push down the stopper. The table chair can be taken out from the table.
WARNING: Never release the table chair while your child is still sitting inside the seat.
6. SECURE THE CHILD IN THE SEAT (fig 5)
Place the child in the seat, secure by fixing the waist belt & crotch belt together. Adjust the
length of the belt to your child's needs. To release the harness, squeeze & open the buckle.
WARNING: (A child's safety is your responsibility.) The child should be harnessed in at all times
and should never be left unattended. The child should be clear of moving parts while making
adjustments. This table chair requires regular maintenance by the user.
Attention: Avoid serious injury from failing and sliding out, always use seat belt & always use as
instructed.
CARE AND MAINTENANCE
IN GENERAL
Please check the table chair function on a regular basis. Make sure that the frame is stable, the
screws are tight. Check the cover occasionally, making sure that the stitching is still firm, and inspect
the quality of the plastic parts. Any broken or worn working parts should be replaced immediately.
Proceed in the same manner with components that are broken, torn, defect or worn-out. Please use
only original hauck replacement parts.
CLEANING THE COVERS
Remove the covers from the frame. Please read the instructions on the sewn-in label before
cleaning. To clean the cover gently, wipe it down evenly using only a damp cloth. As long as there
are no plastic, wood or metal parts on or in the cover, it can be machine-washed at 86°F (30°C) and
medium speed. The cover should be air-dried, but not exposed to excessive sunshine. Please do
not dry the cover in the drier, to avoid shrinking. Do not re-fit the covers until they are completely
dried.
CLEANING THE FRAME
Use only mild soapy water or lukewarm water to clean the metal frame. Plastic parts can be cleaned
with mild detergent cleaners.
GB
7