Care And Maintenance; Cleaning The Filters; Leaving The Machine Unused For Extended Periods - Hotpoint LFFA+ 8M14 Manual De Instrucciones

Care and maintenance

EN
10
Clean the water inlet filter at the tap outlet regularly.
- Turn off the water tap.
- Unscrew the end of the water inlet hose, remove the filter
and clean it carefully under running water.
- Replace the filter and screw the water hose back into
position.

Cleaning the filters

The filter assembly consists of three filters which remove
food residues from the washing water and then recirculate
the water. They should be cleaned if you wish to achieve
the best results in every wash.
Clean the filters regularly.
The dishwasher should not be used without filters, or if
the filter is loose.
• After several washes, check the filter assembly and if
necessary clean it thoroughly under running water, using
a non-metallic brush and following the instructions below:
1. 1. 1. 1. 1. Turn the cylindrical filter C in an anti-clockwise direction
and pull it out (fig. 1).
2. 2. 2. 2. 2. Remove the cup filter B by exerting a slight pressure on
the side flaps (fig. 2).
3. 3. 3. 3. 3. Slide out the stainless steel plate filter A (fig. 3).
4. Inspect the trap and remove any food residue.
N E V E R R E M O V E t h e w a s h c y c l e p u m p ( b l a c k
detail) (fig. 4) .
1
3
After cleaning the filters, replace the filter assembly and fix
it in position correctly; this is essential for maintaining the
efficient operation of the dishwasher.
Leaving the machine unused for
extended periods
• Disconnect the appliance from the electricity supply and
shut off the water tap.
• Leave the door of the appliance ajar.
• When you return, run a wash cycle when the dishwasher
is empty.
*
Only available in selected models.
B
C
2
4