Publicidad
Maintenance
The textile products may be rinsed in clean cold water of
domestic quality. If still soiled it may be washed in warm
water (30 degrees Centigrade maximum) and if required
using pure soap (e.g. Lux soap flakes, stergene) at the
approximate dilution, with pH range 5.5 and 8.5. Rinse
thoroughly and dry slowly away from direct heat.
Detergents must not be used.
For metal products/components remove any excess
moisture with a clean cloth, then allow to dry naturally in
a well ventilated room away from direct heat. If still soiled
wash in clean hot water. Afterwards dry as described
above. After cleaning and drying metal components,
particularly those with moving parts should be lubricated
sparingly using a light oil. Make sure that lubrication does
not come into contact with any parts that rely on friction
with rope and/or with the textile parts.
Instructions for transport and storage
All chemical products, corrosive materials and solvents
should be regarded as harmful.
Always carry and store a product in its bag. Despite its UV
protection it is recommended that this product is stored
away from direct light, in a well-ventilated place away
from all sources of direct heat. Check that it is not too
crumpled or crooked.
Use this product above a minimum of -40°C and
a maximum of 80°C.
Inspection
Lifetime of this product depends on the frequency and the
environment (salt, sand, moisture, chemicals, etc.) in
which it is used. However mechanical damage can occure
during the first use, which can limit the lifetime of this
products only to this first use.
Pay special attention to products, which are subject to
quicker wear or in frequent contact with abrasive surfaces
(e.g. lanyards, sewn slings, fall absorbers).
The user shall check the product:
1. before and after each use
2. during use (condition of particular elements of safety
chain and their proper connection)
3. complete inspection every 3 months.
7
Publicidad
