Wall Installation; External Antenna Installation - MyQ LiftMaster CAPAC Manual De Instalación

INTRODUCTION

Wall Installation

1. Drill (2) pilot holes, spaced 7 in. (17.78 cm) apart, on the wall where the device will be mounted.
2. Use (2) #6 Phillips mounting screws (not included) to attach the device to the wall.
NOTE: For exterior mounting, LiftMaster recommends the use of a polycarbonate NEMA enclosure.
OUTPUT WIEGAND INPUT
GATE 1 OUTPUT 2 1
SDA SCL NO COM NC NO COM NC D1 COM D0

External Antenna Installation

For best cellular coverage position the antennas in the orientation
shown below (perpendicular to each other).
PRE-INSTALL
7 in. (17.78 cm)
WIEGAND 2 INPUT POWER
D1 COM D0 1 GND 2 GND 12V-24V
POWER
INSTALL
ETHERNET
9
NETWORK ACCESS CONTROL
1.3 in. (3.3 cm)