King gates Fred Myo 2 Manual Del Usuario página 5

3- RADIO TRANSMITTER PROGRAMMING
3A - INTRODUCTION
Every operation (both radio transmitter
programming and channel configuration)
is done by the button.
The programming is signalled by the color of
the led, in particular:
- Green led: the operations concerning channel 1.
- Red led: the operations concerning channel 2.
3B - PROGRAMMING OF A RADIO TRANSMITTER ON CHANNEL 1
Press one time the
button on the receiver.
The led switches on
green
3C - PROGRAMMING OF A RADIO TRANSMITTER ON CHANNEL 2
Press two times the
button on the receiver.
The led turns
switches on
red
3D - DELETING OF A RADIO TRANSMITTER
Press three times the
button on the receiver.
The led flashes
orange
3E - DELETING OF ALL RADIO TRANSMITTER
Press three times the
button on the receiver.
The third time, keep
the button pushed.
The led flashes
orange
Within 5 seconds
make a transmission
pushing the desired
button on the transmitter
(the led switches off
and on again)
Within 5 seconds
make a transmission
pushing the desired
button on the transmit-
ter (the led switches
off and on again)
Within 5 seconds
make a transmission
pressing the desired
button on the transmit-
ter (the led switches
off and on again)
During the flashing,
keep the button on the
receiver pressed
until the orange led
becomes fixed on.
Wait 5 seconds, or
push the button on the
receiver.
The led switches off.
End programming.
Wait 5 seconds, or
push the button on the
receiver.
The led switches off.
End programming.
Wait 5 seconds, or
push the button on the
receiver.
The led switches off.
End programming.
Release the button.
When the orange led
turns off, the memory
is erased.