Dynamic Range Control; Downmixing Mode; Dts Neo:6; Speaker Setting - Samsung BD-C6900 Manual Del Usuario

Setup
HDMI
• If your TV is not compatible with compressed
multi-channel formats (Dolby Digital, DTS), the
player may output PCM 2ch downmixed audio
even though you set Bitstream (either Re-
encode or Audiophile) on your setup menu.
• If your TV is not compatible with PCM sampling
rates over 48kHz, the player may output 48kHz
downsampled PCM audio even though you set
PCM Downsampling to Off.

Dynamic Range Control

You can listen at low volumes but still hear dialog
clearly.
This is only active when a Dolby Digital signal is
detected.
Auto : The Dynamic Range Control will be set
•
automatically based on the information provided
by the Dolby TrueHD Soundtrack.
Off : Turn Dynamic Range Control off.
•
On : Choose to listen to a movie at a lower
•
volume without losing clarity of dialog.

Downmixing Mode

Select whether to downmix the multi-channel
audio into fewer channels.
Normal Stereo : Downmixes the multi-channel
•
audio into two channel stereo. Choose when
connected to equipment that does not support
virtual surround functions such as Dolby Pro
Logic.
Surround Compatible : Downmixes multi-
•
channel audio into surround compatible stereo.
Choose when connected to equipment that
supports virtual surround functions such as
Dolby Pro Logic.

DTS Neo:6

You can enjoy multi-channel sound from a simple
2-channel audio source.
Off : Outputs a 2-channel audio signal through
•
the front speakers only.

English
Cinema : Outputs 2-channel movie sound over
•
multi-channels.
Music : Outputs 2-channel music over multi-
•
channels.
NOTE
▪
If you are using an HDMI receiver, this option is
available when you set Digital Output setup to PCM.
▪
You can use this option with analog 7.1ch output
when you don't use HDMI receiver.

Speaker Setting

Set the speaker sound to obtain the best possible
surround sound.
This menu is available only when you are using
7.1ch analog output.
Settings
Display On-Screen Menu Speaker Setting
Audio Disc Menu
System Audio
Network Subtitle
Language
Security
General
< Change
Support
Test Tone
A test tone is sent to L
•
LSB LS LFE in order, so you can make
; ; ;
sure the speakers are set up correctly.
• You can activate the test tone only when no
discs are in the unit.
• The test tone outputs through the 7.1 channel
analog outputs only.
:
:
Front Large
:
Center : Large
:
Surround : Large
Surround Back : Large
Subwoofer : On
Test Tone : Off
" Select ' Return
C R RS RSB
; ; ; ;