Horizon Global 76527 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
l
1. Install hitch – Raise the hitch into position, aligning the slots in the hitch with the attachment holes in the bumper beam. Insert four 1/2" hex bolts with
washers through the hitch and the holes in the bumper beam from the vehicle forward side of the hitch to the rear. Secure with the 1/2" flange locknuts
supplied with the hitch.
Tighten all ½" GR5 fasteners with torque wrench to 75Lb.-Ft. (102 N*M)
2. Torque fasteners -
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2021 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76527, 84527, CQT76527
Bumper Beam
j
k
Figure 1
①
②
l
Sheet 3 of 12 76527NP
Fastener Kit: 76527F
Qty. (4) Hex Bolt
½-13 x 4 ½" " GR5
Qty. (4) Washer flat ½"
Qty. (4) Flange Locknut ½-13
8-8-21 Rev. A