Assembly Instructions; Assembly Instructions Notice - Xplova NOZA ONE Guia De Inicio Rapido

A

Assembly Instructions Notice

Front bottom tube installation
Install according to the direction shown in the figure, press the spring button during
installation, and rotate the front bottom tube slightly to make the spring buckle go
through any hole in the front bottom tube. Then tighten the bolts and the front bottom
tube can be installed.
* Note: 2. The height of the trainer can be
adjusted through the spring button and the
installation of the two holes on the front
bottom tube to adapt to different training
models. The adaptation category is shown
in the figure.
Flywheel/cassette cover installation
After taking out the filler from the flywheel/cassette cover, first tighten the flywheel/
cassette cover onto the flywheel, and then lock the two screws, as shown in the figure.
* Note: 1. The flywheel cover plays a role
in protecting the machine, personnel
safety and aesthetics purpose, please be
sure to install it in place!
I
SSEMBLY NSTRUCTIONS
* Note: 1. The part marked in red is a
plastic pipe sleeve, which is installed to
prevent the metal pipes from rotating each
other, please do not discard it.
EN-3
* Note: 2. For detailed installation
methods, please refer to the specific
chapters.

Assembly Instructions