USB charging function:
•
The USB port can be used to charge electrical devices such as
smartphones. To do this, remove the protective cap and connect your USB
cable (not included). The USB connector has an output voltage of 5 V / 1 A.
When charging is complete, replace the protective cap.
Tilt angle:
•
You can adjust the tilt angle of the fan by tilting the fan head manually. If
necessary, tighten the side screws to maintain the desired tilt.
Protective devices:
•
This appliance has thermal protection and overcurrent protection. If the
circuit is overheated, the protection devices are activated by automatically
cutting the circuit for safety reasons. If you notice damage to the product,
discontinue use and contact the manufacturer or an authorized service
center.
CLEANING AND CARE
•
It is recommended to clean the fan every month.
•
Always unplug the appliance from the wall outlet before cleaning. Never
immerse the plug, power cord or the entire appliance completely in water
or other liquids.
•
Use a damp, soft cloth to clean the surface. Then wipe the unit with a dry
cloth.
•
Do not use aggressive or chemical cleaning agents or abrasive cleaners
(such as steel wool).
•
If you do not use the fan for a long time, store it in a cool, dry place out
of the reach of children. Do not store the unit in warm places exposed to
direct sunlight.
•
If the appliance is very dirty, you can remove the front protective grille.
Make sure the appliance is turned off before removing it. Loosen the
screws and remove the protective grille. The fan blades must not be
dismantled. Use a damp, soft cloth for cleaning and a mild detergent if
necessary. Wipe the appliance with a dry cloth. After cleaning, screw the
front protective grille back on tightly.
EN
13