Denver ACT-320 Manual De Instrucciones página 5

Start using
1. Charge the built-in lithium battery
Connect the camera to the computer for charging, at this time, the charging indicator will be in blue, and it will be off
after charging. Generally, it takes 2-4 hours to charge the battery.
2. Use the storage card
2.1. Push the Micro SD card into the slot till it is in place as per the instruction in concavely engraved words by the
storage card slot.
2.2. To take out the Micro SD card, press the tail of the storage card inwardly softly and it will be popped out.
Please notice: Some UHS (ultra high-speed) cards do not work, as they are not 100% backward compatible
Note: There's no built-in memory unit in the camera, so make sure to insert a storage card into it prior to use (it is
recommended that a Micro SD card of better quality be used).
3. Power on/off
3.1 Power on: Press Power key for 3 seconds, the screen will be on and the camera will be started.
3.2. Power off: Press Power key for 3 seconds when the camera is in the idle state to turn it off.
3.3. Power off when the camera is lack of electricity. When electrical quantity of the battery is very low, an icon of
will be displayed on the LCD screen, prompting you to charge it in time.
4. Video recording mode
After power is on, the camera will enter video recording mode directlyand in preview mode, press Shutter key to
start video recording; Press it again to stop shooting. If the memory card is full or electrical quantity is low, it will
also stop shooting.
_ _
ENG 03