INTERTECHNO ITLM-1000 Manual Del Usuario página 12

To teach the transmitter, keep the Learn button pressed for approx. 1 - 2 seconds.
The LED flashes.
3) Press the "ON" button immediately on the transmitter.
The receiver now switches ON and OFF twice to indicate that the code has been
accepted.
DONE!
It is possible to configure and store up to 16 different codes.
This makes it also very easy to resolve any group switching planned.
Further remote receivers can be switched ON and OFF individually or together.
The codes remain stored in the receiver even after a
power failure or retrofitting.
How to erase codes
Erasing individual codes:
Follow steps 2.) and 3.) but press the transmitter's "OFF" button instead of
the "ON" button.
Erasing all codes:
Keep the Learn button (L) pressed (approx. 6 sec.)
until the LED starts flashing.
Now, press the Learn button (L) again shortly.
This erases all codes.
No transmitters are required in this process.
To view the Declaration of Conformity, please visit www.intertechno.at/CE