Loose Parts; Installing The Kit - Eurosystems Slalom 76 Manual Del Usuario

Rear Discharge Deflector Kit
for Rear Engine Riders
Model No. 79472

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
1

Installing the Kit

Parts needed for this procedure:
1 Deflector
2 Washer
2 Nut
2 Bolt
Procedure
1. Park the machine on a level surface.
2. Disengage the power take-off (PTO).
3. Shift the machine into neutral.
4. Set the parking brake.
5. Stop the engine, wait for all moving parts to stop,
and remove the ignition key.
If you leave the key in the ignition switch,
someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition.
6. Raise the grass collector cover.
7. Remove the bagging assembly.
8. Secure the deflector to the rear plate with the bolts,
washers, and nuts provided in the kit (Figure 1).
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
Deflector
Washer
Nut
Bolt
No parts required
Register at www.Toro.com.
Qty.
1
2
Install the kit.
2
2
Convert from recycling to rear
–
discharging.
1. Deflector
2. Bolts
3. Washers and nuts
Note: The grass collector cover can remain attached
to the tractor.
2
Converting from Recycling to
Rear Discharging
No Parts Required
Procedure
1. Remove the Recycler
2. Move the height-of-cut lever into the lowest position.
Form No. 3361-308 Rev A
Installation Instructions
Use
Figure 1
4. Discharge tube
5. Rear plate
cover from the mower.
®
Original Instructions (EN)
Printed in the USA
All Rights Reserved