Ugin PROGRAMIX 25 Modo De Empleo página 26

4)
INDICATOR OF THE UNIT DISPLAYED ON 3
Two red lights indicate units of temperature and heating rate (°C and °C /min) and two green lights
indicate units of time (hours and minutes).
5)
MODE KEY
This key is pressed to switch from the temperature/time display mode to the temperature only display
mode. See paragraph 3 above.
6)
FORWARD KEY
7)
REVERSE KEY
7.1) ln stand-by position:
Pressing the or the
7.2) ln programming position:
Pressing the
Pressing the key
8)
STOP OR START TOUCH CONTROL
After checking the number of the program selected, the
cycle. AIl the indicators on the panel light up simultaneously.
By pressing the
9)
CYCLE ADVANCE KEY
During program set-up, this key is pressed to choose the parameters to be programmed.
.During the heating cycle, the
10)
PROGRAM SELECTION KEY
This key accesses program selection.
Once is pressed, program parameters can be entered or modified using the
or controls and the
During that time, the program number blinks.
Once the program has been entered, pressing the
The program number then stops
key modifies the program number.
key increases the value of the parameter displayed on
decreases that value.
touch control a second time, the cycle is cancelled.
key is pressed to skip a stage and move on to the next one.
key.
blinking.
3
control is pressed to start the heating
key a second time "locks" the program.
24
PROGRAMIX 25/50/100
.