Zerowatt ZL 831/1 ECO Manual De Instrucciones página 15

Glass button
By pressing this button in conjunction with the programme your
dishwasher will operate the wash at 45°C.
Recommended for delicate glass.
Pre-heating for rapid wash
For rapid wash, the water must be pre-heated.
Turn the knob to the symbol and press the button .
This should be done 15 minutes before you actually load
the dishwasher. While you are finishing your meal, the
dishwasher will automatically fill with water and then bring it to
the correct temperature. So when the dial wash is on stop
position, the pilot light «R» comes on and the machine is ready
to be loaded with dishes.
Switch it off by pressing the button. Open the door, put the
detergent in the dispenser and load the dishes carefully in the
two baskets. One convenient way of doing this is to put the
dishes in alternate grooves of the basket.
18' rapid wash
Turn the knob to the symbol and press the button.
After approximately 18' the wash will be completed. Switch off
by pressing the button and open the door leaving it slightly
ajar to aid the natural drying process.
The cycle ends
When the program handle reaches the symbol, the cycle
ends.
Push the On-Off button to cut power to the dishwasher and
then only open the door.
28 29