FAAC XIB Manual De Instrucciones página 3

BUS PHOTOCELLS "2easy"
ON ON
DS1 DS1
1 2 3 4 1 2 3 4
BUS BUS BUS BUS
-
+
PHOTOCELLS AT CLOSURE
OTHER DEVICES WITH N.C. CONTACT
-
+
PHOTOCELLS AT OPENING
DO
NOT T
ON
DS1
1 2 3 4
On the BUS photocells connected to
J2 of the "XIB", NEVER configure DS1
as in the figure
OFF SLOW FLASHING
(FLASH EVERY 5 secs.)
"XIB" board J3 OP terminal
open.
DL1
broken
E.G. PHOTOCELL
or not
ENGAGED,
powered
NOT ALIGNED OR
NOT CONNECTED (*)
"XIB" board J3 CL terminal
open.
DL2
broken
E.G. PHOTOCELL
or
ENGAGED,
not
NOT ALIGNED OR
powered
NOT CONNECTED (*)
" XIB " BUS INTERFACE
ON
DS1
1 2 3 4
BUS BUS
DEVICES WITH N.C. CONTACT
-
+
-
+
BUS COUPLING ON FAAC control board
ON
DS1
1 2 3 4
ON STEADY BEAM
J3 OP terminal
closed
E.G. PHOTOCELL
NOT ENGAGED
AND ALIGNED
J3 CL terminal
closed
E.G. PHOTOCELL
NOT ENGAGED
AND ALIGNED
XIB
ON
DS1
1 2 3 4
BUS BUS
( RED )
CL
BUS
( RED )
OP
XIB
J3 CL
( GREEN )
J3 OP
( GREEN )
*
( ) If no device should be connected to
the "J3 CL" or "J3 OP" terminals of the "XIB",
the unused terminal must be connected
to the negative ( - ) of the FAAC control
board.
DIAGNOSTICS
FAST FLASHING
(FLASH EVERY 0.5 secs)
BUS photocell, connected to the
J2 terminal of the "XIB", with the
configuration of:
DS1: OFF;ON;ON;ON
USE ANOTHER
DS1 COMBINATION
BUS photocell, connected to the
J2 terminal of the "XIB", with the
configuration of:
DS1: ON,ON,ON,OFF
USE ANOTHER
DS1 COMBINATION
CL
DL2
J1 Connector to be connected to
the "2easy" BUS coupling
on FAAC control board
J2 Terminal board for the connection
of BUS accessories
(2easy photocells, encoder etc..)
Terminal for the connection of
devices
operating at closure (CL) ,
with N.C. contact
(E.G. PHOTOCELLS, EDGES, ETC...)
Terminal for the connection of
devices operating at opening (OP)
with N.C. contact
(E.G. PHOTOCELLS, EDGES, ETC...)
DL1 LED for diagnostics of devices
connected to the J3 OP terminal
(see diagnostic table)
DL2 LED for diagnostics of devices
connected to the J3 CL terminal
(see diagnostic table)
ALTERNATE FLASHING OF
"DL1" AND "DL2" LEDs
The "XIB" BUS interface
is not connected to a
"2easy" bus
output on the
FAAC control board
CONNECT
THE "XIB" INTERFACE
T O T H E " 2 e a s y " B U S
TERMINAL ON THE FAAC
control board
DL1