Technical Data - MO-EL 315 Uso Y Mantenimiento

Make sure that the wall where you plan to mount the appliance is solid and free of
electrical cables or water pipes inside.
For safety reasons, never attach the device near bath tubs, wash basins, showers,
or other fittings where there may be water.
This hand dryer must be installed out of the range of a person using the bath or
the shower.
1. Apply the drilling template on the wall using adhesive tape and punch in the points
marked.
2. Drill holes in the wall using a 9 mm bit in the 5 points indicated.
3. Loosen the three Allen screws that attach the body to the base, then remove the body.
4. Hookup:
• Art. 315: as this is a Class II device, the earth connection does not have to be
made. Connect Phase and Neutral on the two free terminals that are indicated by
the arrows.
• Art. 332: as this is a Class I device, the earth connection has to be made. Connect
Phase and Neutral on the two free terminals that are indicated by the arrows; con-
nect the earth on the terminal that is indicated by the symbol
5. Connect the 5 screw anchors to the base using the screws provided, leaving some slack;
place the 5 screw anchors in the holes made previously (point 2), then press the base
against the wall; tighten the screw thoroughly.
6. Refit the body, making sure that the photoelectric cell wires do not touch each other.
Detection sensitivity adjustment is made using the potentiometer shown in the diagram,
with higher sensitivity to the left and lower to the right. If sensitivity is too high, the device
will function continuously in illuminated rooms. In all cases, the dryer must be attached in
such a way that the sensors are at least 50 cm from horizontal surfaces in order to prevent
infrared reflection.
During transport, one of the three sensors may come out of its seat slightly. For the best
dryer operation, the sensors must be well-seated (especially the middle one). If necessary,
carry out this operation carefully, making sure that the tangs of the LEDs do not come into
contact with each other. N.B. The blue sensors are infrared transmitters and the white sen-
sor is a receiver.
Use: Move your hands close to the appliance, it will automatically activate. On moving away
the appliance will automatically shut down after a few seconds.

TECHNICAL DATA

Power supply:
Rated power:
Air speed:
Protection level:
Insulation class:
Dimensions (cm):
315
220-240 V ~ 50-60 Hz
2125 W
28.5 m/s
IPX3
32x25.7x15 cm
5
332
220-240 V ~ 50-60 Hz
2125 W
28.5 m/s
IPX3
I
32x26x15 cm