Technical Data - MO-EL 725 Manual De Uso Y Mantenimiento

into the holes.
2. Screw out the 2 hexagon socket head cap screws from the shell by
means of the hexagon wrench enclosed with the appliance (Fig. 1).
3. Discharge the shell (Fig. 2) and meanwhile disconnect button wire (Fig.
3); please do not use too much strength when opening the shell be-
cause the wire could be damaged .
4. Fix the holder to the wall by means of the 4 fixing screw enclosed with
the appliance (Fig. 5); then connect button wire (Fig. 6).
5. Insert the shell into the holder from the top, pressing tightly the bottom
of the holder at the same time and paying attention that the wires do not
remain clipped between the parts; then fasten the shell by means of the
2 screws and the hexagon wrench (Fig. 6).
6. Having fixed the appliance to the wall, connect it to the power supply.
OPERATING
After washing your hands, put them near to the hole located at the bottom
of the nozzle air diffuser and push the button in the frontal part to switch
on. The warm air flows immediately. Push the button again to stop the
flow. A safety device causes automatic shutdown after 10 seconds of
continuous use; push the button again to restart. To short the work time,
please shake the water away from your hands before the use.
The nozzle can be rotated to direct the air flow. To prevent accidental falls
of objects inside, it is suggested to locate the hole downward when the
appliance is not in use.

TECHNICAL DATA

Power supply
Rated power
Air speed
Protection level
Dimensions (cm)
AC 230 V ~ 50 Hz
2300 W
22 m/s
27 x 21 x 23 (H)
8
IPX1