Cleaning And Maintenance - Sinbo SAH 6107 Manual De Instrucciones

CLEANING AND MAINTENANCE

How to Clean the Water Tank
1. Fill the water tank with water.
2. Put a mild detergent and then shake it well.
3. While shaking, hold it with both hands and do not hold it with the handle.
4. After shaking, remove the water and rinse it thoroughly.
NOTE: The water tank should be cleaned once a week.
How to Clean the Transducer & Water Basin
1. To remove the water residue, pour approximately 2 tbsp. of white vinegar and add
water into the water basin. Make sure it fills the entire water basin but not all the way
to the rim.
2. Leave the water with vinegar for at least one half hour.
3. Brush the solution in the transducer and in the areas encrusted with water residue.
Use the brush provided by the unit or with soft bristled brush.
4. Discard the solution and rinse it thoroughly.
NOTE: Clean the Transducer & Water Basin at least once a month to prevent the
accumulation of water residue.
TROUBLE SHOOTING
Humidifier does not work at all.
Make sure it is properly plugged into the convenience outlet and the Mist Control Knob
is in ON position.
The Light Indicator is on but no mist or very little is being emitted.
Make sure that nothing blocks the Adjustable Mist Nozzle.
Check if there is water in the tank.
White dust appears outside the humidifier.
The water you are using might have too minerals. Change to distilled or filtered water.
- 8 -