Safety Instructions; Storage Instructions - invicon StoneLux Pyrosil Instrucciones De Uso

Application
Direct the pale blue area of the flame
onto the surface being treated
For successful application, keep the
flame moving over the surface for at
least five seconds.
After allowing the material to cool for
a short period of time, apply a coat of
StoneLux Primer.
Important
If the distance between the flame and
surface is incorrect, the result may be
ineffective. It is essential to avoid loca-
lized overheating, as this may cause
undesirable discoloration.
Contamination (e.g. contact by finger)
adversely affects the bond to the sub-
sequent layers. Therefore, the pyrolytic
treatment should be carried out as one
continuous uninterrupted procedure.
The flame is directed onto the area in need
of repair. Keep the flame moving over the
surface for at least 5 seconds
Note
Only use original StoneLux gas cart-
ridges to refill the torch. Do not open
empty cartridges or throw them into
open fire to avoid explosion hazard.

Storage instructions

Store containers in a cool place at
about 15°C (59 °F).
Keep StoneLux Pyrosil torch
and gas cartridge out of the reach
of children.
Protect from exposure to direct
sunlight.

Safety instructions

– Highly inflammable
– Store in a cool place
– Store container in a well-ventilated
place
– Keep away from sources of ignition
– No smoking
– Take measures against electrostatic
charges
– Use only in well-ventilated areas
– Do not force open or incinerate
empty gas cartridges
– StoneLux torch and gas cartridge
are pressurized containers
Date information prepared
11/2005