Safety Precautions
Read the following recommended safety precautions carefully.
Power Source
Before plugging in for the first time, read the following section carefully.
This device should be operated only from a 220-240V AC, 50 Hz outlet.
Be sure that the power supply voltage of the area be used meets the required voltage and you select the correct voltage
setting for your device.
Power Cord
Do not place the set, a piece of furniture, etc on the power cord or pinch the cord.
Do not unplug the appliance by pulling from the power cord and never touch the power cord with wet hands as this could
cause a short circuit or electric shock.
Never make a knot in the cord or tie it with other cords. The power cord should be placed in such a way that they are not
likely to be stepped on.
needs to be replaced, it should be done by qualified personnel.
Moisture and Water
Cleaning
Ventilation
The slots and openings on the device are intended for ventilation and to ensure reliable operation.
overheating, these opening must not be blocked or covered in anyway. When installing this unit make sure to leave space
sufficient around the unit to ensure the ventilation to improve heat radiation.
Do not expose the unit to extreme conditions of heat, cold or moisture
Heat and Flames
A damaged power cord can cause fire or give you an electric shock.
Do not use this device in a humid and damp place (avoid the bathroom, the sink in the kitchen,
etc).
Do not expose this device to rain or water, as this may be dangerous and do not place
objects filled with liquids, such as flower vases, on top.
If any solid object or liquid falls into the cabinet, unplug the connected device(s)
and have it checked by qualified personnel before operating it any further.
Before cleaning, unplug this device from the wall outlet.
aerosol cleaners. Use a soft and dry cloth.
The device should not be placed near to open flames or sources of intense heat such as an
electric heater.
Ensure that no open flame sources, such as candles, are placed on top of the
device. Batteries should not be exposed to excessive heat such as sunshine, fire or the like.
Handle the power cord by the plug.
When it is damaged and
immediately
Do not use an aggressive liquid or
To prevent