Transporting, Storing The Device; Troubleshooting; Maintaining The Device - Walimex Pro LED Round Manual De Instrucciones

7.2 Switch the unit on / off - dimmer function
• Switch the video lamp on with the On / Off control button.
• Turn the dimmer controller to adjust the desired light intensity or adjust the
Bi-Colour effect (model dependent).
• After use operate the On / Off controller to switch off the LED lamp.

8. Transporting, storing the device

WARNING
Danger of fire caused by hot parts of the equipment. Allow the device to cool
down completely.
• Switch off the device (See „Switching the device on, off)
• Allow the device to cool down completely
• Unplug the power supply cable from the device
• If necessary clean the device (See „Cleaning the device")
• Lay the device and all disassembled elements into the original article packaging
box and transport of store as specified in the technical specifications. See
technical specifications.

9. Troubleshooting

Problem Possible cause
The device is switched Mains cable not plugged in
on, but does not show or not plugged in correctly.
any function. Power packs are almost
exhausted
The device is switched off
The device has not enough
The illuminant does power
not light
The device is defective
28
Remedy
Plug the mains cable in
correctly
Charge the power packs
Switch on the device
Increase the power of
the dimmer control
Repairs must only be
carried out by a skilled
electrician

10. Maintaining the device

WARNING
Danger of electric shock and danger of fire due to short circuit.
Have the device repaired by an electrician immediately.
WARNING
Danger of cutting and splintering caused by breaking or bursting illuminants.
Cleaning
WARNING
Danger of electric shock
■ Do not bring the device into contact with moisture or water.
■ Always pull out the power supply plug before starting to clean the device.
Device Cleaning
Housing Use a microfiber cloth to remove light and stubborn dirt.
Illuminant Clean off dirt with a dust brush or a dry, soft cloth
NOTE
Do not clean the illuminant with water. Even slightest residues on the
illuminant can cause bursting of the illuminant.
Changing the illuminant
WARNING
For this device use only LED illuminants as specified.
LEDs must only be replaced by a skilled electrician. Within the warranty period
you should only return the device to the manufacturer under the specified
address.
29