Control Operation; Cleaning And Maintenance - Best ACR1 Guia De Inicio Rapido

English
READ AND SAVE THESE INSTRUCTIONS
EN
Your Best ACR1 remote control is a Radio Frequency
(RF) wireless device used to operate the fan, lights, and
delay-off feature on compatible Best range hoods. Refer
to your hood installation manual or product specifi cation
sheet to ensure your hood is compatible with Best model
ACR1 remote control.
Unlike Infrared (IR) remotes, which are the most common,
RF remotes are easier to use because they do not require
line of sight, so they do not need to be aimed directly at
the equipment they are controlling. RF is a very conve-
nient, reliable method to transmit commands without wi-
res for the operation of your compatible range hood. This
system will offer exceptional performance in most cases.
Although signals will often travel great distances, as well
as around and through structures/walls, there are some
limitations to the operating range. See troubleshooting
guide on page 3 regarding these limitations.

CONTROL OPERATION

When a button is depressed on the remote control, it
sends a coded signal to the receiver installed on a Best
compatible hood, telling it which function to activate.
P1
P3 P5 P4
P2
P1: Activate/deactivate delay-
off (10 minute)
P2: Filter change indication
timer reset
P3: Decreases fan mo-
tor speed until turned off
(4>3>2>1>OFF)
P4: Turns fan motor on
and increased speed
(OFF>1>2>3>4)
P5: Turns lights on/off
L1: LED Indicator Ring
2
LINKING PROCEDURE
There exists a slight possibility of interference from other
RF remote controls (garage door transmitter, home and car
security systems, remote control paddle fans, other range
hoods installed nearby). If the user experiences interferen-
ce, the Best ACR1 remote control must be "re-linked" with
the range hood that it intends to operate. To re-link the
ACR1 remote control with the hood, turn off the hood fan
and lights. Press and hold button P1 on the remote con-
trol for 3-seconds (the LED indicator ring will illuminate).
Determine the type of control on your hood (below), and
press the button as indicated within 3-seconds of initiating
the re-linking procedure. Note that in most cases, this will
not be necessary. The product is shipped from the factory
(transmitter and receiver) already linked. Assuming there
are no interference issues, the user won't need to re-link.
P1
P3
P2

CLEANING AND MAINTENANCE

Clean surfaces with a damp, clean cloth and mild detergent
only. Do not immerse in water. Your remote is considered
to be "splash-proof" not "waterproof". Your Best remote
transmitter is a user friendly device designed for years of
trouble free operation. Under most circumstances it should
require only periodic battery replacement. The transmitter
is powered by a long life A23-style 12V battery available at
most hardware stores or home centers. The replacement
battery can also be ordered directly from the factory (P/N
S97018267). To change the battery, remove the battery
cover by removing the battery cover screw. Remove the
existing battery and discard properly with consideration to
local codes and recycling guidelines. Install the new battery
while ensuring the "+" side of the battery lines up with the
"+" terminal of the remote. Replace cover and screw.
P5
P4