Harper HTM50 Manual Del Usuario página 15

Adjustable lever
·The lever is conveniently located near you thumb(if you're right handed)
so it can easily be adjusted while the clipper is in your hand.
·The lever adds versatility to your clipper by allowing you to gradually
change the closeness of your cut without an attachment comb.
·When the lever is in the uppermost position, the blades will give you
the closest cut and leave the hair every short. Pushing the lever
downward gradually increases the cutting length.
·In its lowest position, the lever will leave the hair approximately the
same length as a # 1 comb.
·The lever will also extend the use of your blades since a different
cutting edge is used in each setting.
·In addition, if extremely heavy hair cutting has jammed the blades, it
will help you remove hair that has become wedged between the two
blades without removing the blades. (Fig. 27)
A . Close cut
B . Longer cut
While the clipper is running , rapidly move the lever from "close cut" to "longer cut" a couple
of time. Dongthis each time after; you have finished using your clipper will
help to keep the blades clear of cut hair. If your clipper stops cutting and
this does not help, your cutting blades are dulled. Replace them with
new blades.
IMPORTANT SAFEGUARDS
When using electrical appliances, especially when children are
present, basic safety precaution should always be followed,
15