Publicidad
Step 8
Carefully turn your unit over onto its front edges. Unfold the
å
BACKS (R and S) and lay them over your unit.
Make equal margins along all four edges of the BACKS (R
å
and S). Push on opposite corners of your unit if needed to
make it "square".
Fasten the BACKS (R and S) to your unit using the NAILS (RR).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHTS (C and D).
NOTE: Perforations have been provided for access through the
å
LOWER BACK (S). Carefully cut out the rectangle for proper
ventilation of your CPU.
Cut-out
www.sauder.com/services
These holes must line up over
the UPRIGHTS (C and D).
S
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(48 used in this step)
R
404958
RR
NAIL
Page 13
Publicidad
