Publicidad
Step 11
Fasten the DRAWER RIGHT (35AY) and DRAWER LEFT (35AZ)
å
to the KEYBOARD SHELF (J) and PRINTER SHELF (N). Use
eight BROWN 1" FLAT HEAD SCREWS (MM).
Turn the CORD CLIP (GG) into the KEYBOARD SHELF (J).
å
NOTE: The CORD CLIP is used to hold your keyboard cord
å
against the KEYBOARD SHELF.
The DOORS (I) are not shown in this step.
å
To insert the KEYBOARD SHELF (J) into your unit, tip
å
the front of the SHELF down and drop the rollers on
the SHELF behind the rollers on the unit. Lift the
front of the SHELF up and slide it into the unit.
Repeat this process to insert the
PRINTER SHELF (N).
NOTE: The DOORS should be open
å
completely to pull out the KEYBOARD
and PRINTER SHELVES.
N
Page 16
Finished edge
J
Roller end
Finished edge
Roller end
J
GG
BROWN 1" FLAT HEAD SCREW
(8 used in this step)
404958
N
MM
www.sauder.com/services
Roller end
Roller end
Publicidad
