Intended Use - Makita DGP180 Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Rated voltage
Grease capacity
(with A-type barrel)
Grease capacity
(with B-type barrel)
Maximum operating pressure
Maximum flow rate
Applicable grease type
Hose length
Overall length
Net weight
NOTE: The barrel type (A-type or B-type) varies depending on the country.
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.

Intended use

This tool is intended for dispensing grease.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-1:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Cartridge
Bulk
Cartridge
Bulk
Slow speed mode
Auto speed mode
With A-type barrel
With B-type barrel
) : 76 dB(A)
pA
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
8 ENGLISH
DGP180
D.C. 18 V
410 g
455 g
450 g
570 g
69 MPa
145 ml/min
290 ml/min
NLGI No.0 - No.2
1,200 mm
411 mm
449 mm
4.8 - 6.1 kg
DC18SH