English; Disassembly - b&o BeoVision 1 Manual De Reparacion Y Servicios

6-1
Disassembly, English

DISASSEMBLY

Back cover
Contrast screen
Speaker front cloth
Placing the main chassis into
service position
PCB10 Sound output
Important!
The TV must never be placed on the front glass.
A service stand part no. 2752068 can be used for placing the TV during
service.
Remove four screws.
Lift out the lower edge of the back cover approx. 10cm. Now the back
cover can carefully be pulled out.
Turn the screw below the glass in the right-hand side 90 degrees clockwise.
Turn the screw below the glass in the left-hand side 90 degrees
anticlockwise.
Pull down the screws, notice the contrast screen will fall outwards, but it
will not fall off.
Remove the contrast screen by holding it up straight on the TV and then
pull it out a bit in the right-hand lower corner and the left-hand top
corner.
Reinstalling:
Place the glass holding it in the lower right-hand corner and the upper
left-hand corner on to the TV. While holding it, push up the right-hand
screw. Then push in the glass in the lower left-hand corner, and push up
the left-hand screw. Fasten the screws.
Carefully pull out at each corner of the front cloth and at the same time
pull it downwards.
Unscrew the two screws A at the left-hand side of the chassis. Then open
the chassis to the right, until it is 180 degrees opposite to the initial position.
Then lock the chassis by pushing up the holder at the top of the chassis.
A
PCB4
A
Remove the front cloth.
Unscrew the four screws B holding PCB10.
B