Entering Of Wheel Data For Standard Programs; 31 8.3.1 Measuring The Distance; Measuring The Width; 31 8.4 Entering Of Wheel Data For Non-Standard - Sicam SBM 55 NW Manual Original

"
Blue symbols indicate the positions of the balancing
planes for the balancing program selected.
8.3 Entering of wheel data for standard
programs
i
Wheel data is entered in accordance with the selec-
ted balancing program.
For wheel balancing, this must be characterised by
entering the following parameters:
$
Distance: it is the distance between wheel and
machine;
$
Diameter: it is the nominal diameter indicated on
the rim.
$
Width: for standard programs it is the width of
the rim;
8.3.1 Measuring the Distance
1. Position the distance calliper gauge on the rim and
detect the value in position "K" on the millimetric
scale;
Sicam srl società unipersonale
Balancing a wheel | SBM 55 NW | 43
2. Using the <-> or <+> key for rim distance, enter the
detected rim distance value in the "mm" unit.
8.3.2

Measuring the Width

1. The rim width can be read off the rim or determined
with the measuring compasses.
Fig. 11: Determining rim data with measuring compasses
1 Rim width scale
2 Inner tip for rim width
2. Using the <-> or <+> key for rim width, enter the de-
tected rim width value in the "inch" unit (Tab. 1 pos.3)
.
en
|
1 695 656 076 2012-03-28