Nolan N103 Seguridad E Instrucciones página 16

Push the VPS upwards, making sure that the side slider is moving backwards (Fig. 10A).
Check the correct VPS operation by moving the left side slider forwards (Fig. 10A) and
backwards (Fig. 10B) until you hear the clicks meaning that it is in the relevant positions.
If necessary, repeat the above-mentioned steps.
- If the visor and/or VPS opening/closing mechanisms are damaged or malfunctioning,
please contact a Nolan authorised dealer.
- Do not use the helmet if the VPS has not been assembled properly.
WARNING
- Since the VPS does not assure you the same protection as the one provided by the
visor, it has to be used only when the helmet visor is pulled down.
• WIND PROTECTOR
This accessory allows improved helmet performance under certain conditions of use.
The Wind Protector prevents unpleasant infiltrations of air under the chin.
See Fig. 13 for the assembly and disassembly.
WARNING!!!
The Wind Protector is easily removable. You can check the correct assembly of this acces-
sory by pulling it gently towards the inner part of the helmet with your thumb and forefin-
ger. If it moves, repeat the assembling operations.
• REMOVABLE INNER COMFORT PADDING
(only for versions equipped with removable inner padding)
To remove and/or reassemble the inner comfort padding open the helmet chin guard and
lift the VPS.
CHEEK PAD REMOVAL
1.1 Open the chin strap (see specific instructions) and pull the front part of the left
cheek pad towards the inside of the helmet to release the 3 snap buttons on its
back (Fig. 14).
1.2 Remove the padding of the left cheek pad from the helmet by pulling the left chin strap
out of the cheek pad slot.
1.3 Repeat the same steps for the right cheek pad.
N. B.: it is not necessary to remove the polystyrene cheek pads with the locking
holes for the fastening buttons of the pads from the helmet shell.
LINER REMOVAL
1.4 Release the roll-neck eyelet from the frame fixed to the outer shell (Fig. 15).
1.5 Release the left rear fastening flap from the support fixed to the inner shell by slightly
deforming the shell sealing edge and slightly pulling the comfort padding in the helmet
neck-ring area towards the inside (Fig.16).
Then repeat the same steps to remove the central flap as well as the right rear flap.
16