RIB ACG9418 Manual De Instrucciones página 6

G
B
Selection key A
Programming key B
To access the parameters, press programming key B for at least 2 seconds (with the help of
a paper clip, for example).
You will see parameter A3.
To scroll through the parameters, press the ENTER
PARAMETER
FUNCTION
(ENTER key)
Obstacle
detection
Maximum
opening speed
Maximum
closure speed
Opening deceleration
speed
Closure deceleration
speed
Progressive stop
Electric lock function
Partial opening
Automatic closure
time from OPEN order
Dynamic autom.
closure
Dynamic partial
opening
Emergency batteries
Anti-wind function
Photo test
Interlock
Opening
braking
Closure braking
Approach in closure
RS485 serial BUS
address
Acceleration
ramp
key.
CAUTION: the automation has a default setting and the parameters are indicated in bold type.
A Key = 0
Ramp 0.1 sec.
Immediate stop
Always off
One order opens,
another one closes
Not enabled
Not enabled
With batteries
It opens when there is no
standard operation
Not enabled
Not enabled Enabled at each closure
Very slow
Disabled
function
Press key A
to change the value.
To exit programming, wait for 10 seconds. The screen will display the text
A Key = 1 A Key = 2
Very high High
Very slow Slow
Very slow Slow
Very slow Slow
Very slow Slow
Ramp 0.2 sec.
Always active
1=5% 2=10% 3=20% 4=40% 5=50% 6=60% 7=70% 8=80%
1=10sec 2=20sec 3=30sec 4=40sec 5=50sec 6=60sec 7=70sec 8=80sec 9=90sec
3 consecutive closures not completed = 10 sec. increase
3 consecutive closures not completed = total opening
It closes when there is no
power supply power supply
Low Medium
Night automatic quick
selector
High Medium-high
High Medium-high
Slow Medium
Possibility of connecting a PC for the centralised management of automations (max 31)
1=0,2sec 2=0,4sec 3=0,6sec 4=0,8sec 5=1sec 6=1,2sec 7=1,4sec 8=1,6sec 9=1,8sec
6
LCD Display
ENTER
key
A Key = 3
High
Slow
Slow
Slow
Slow
Ramp 0.2 sec.
automatic closure set
High
Medium-low
Medium-low
Quick
.
A Key = 4
Very low
Very quick
Very quick
Very quick
Very quick
Ramp 0.4 sec.
Low
Low