Yamaha FJR1300AP Manual De Instrucciones página 15

Right handlebar switch lead
Hazard switch lead
Wire harness
Clamp
Coupler (for siren)
Grip warmer lead
Stay
Front wheel sensor lead
Connect the right handlebar switch lead to the wire harness.
Connect the hazard switch lead to the wire harness.
Clamp the wire harness, hazard switch lead, handlebar switch lead and grip warmer
lead. Do not clamp the front wheel sensor lead.
Route the wire harness along the front side of the frame and clamp the white tape
marking section of harness at the top of the hole in the frame.
Clamp the handlebar switch lead, the grip warmer lead and the hazard switch lead,
and pass them through the hole of the stay. Set the clamp end downward without
cutting it off.
Clamp the handlebar switch lead, the grip warmer lead, front wheel sensor lead and
the hazard switch lead, and pass them through the hole of the stay. Set the clamp
end downward without cutting it off.
-9-
MAINTENANCE