Controls And Operation - Rollei GO! Manual Del Usuario

Mount the Smartphone
Ensure the Rollei GO! is turned OFF prior to attaching and balancing your phone.
A Mount the Smartphone horizontally: Place the phone in position by opening the holder. It
is recommended to position the smartphone as close to the motor as possible. If the Smartphone
doesn't remain levelled, you can loosen the adjustment screw on the roll arm, then adjust the length
of the arm until it is balanced.
B Mount the Smartphone vertically: To mount your smartphone vertically, loosen the retaining
screw and rotate the holder by 90 degrees. Then tighten the screw again. Place the Smartphone in
the holder. If the Smartphone doesn't remain levelled, you can loosen the adjustment screw on the
roll arm, then adjust the length of the arm until it is balanced.
Charging the Smartphone
Wireless charging
• Quickly press the On/Off button twice while the Rollei GO!
is turned on to start or stop the wireless charging process.
• Note: If the battery level is less than 20%, the wireless
charging function is not available.
USB port
• Your smartphone can be charged via the Rollei GO! USB port.

Controls and operation

To start the Rollei GO! press and hold the On/Off button
for 3 seconds. To switch the motors to standby mode, press the
On/Off button shortly. The motors will then switch off.
Push the button again to restart the motors.
A A
FM
9
B