Fcc/Ic Statement - i.safe MOBILE M93A01 Manual Del Usuario

FCC/IC STATEMENT

The FCC/IC Statement can be found under downloads on the product page of our website:
www.isafe-mobile.com/en/products.
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it must
be withdrawn from use and removed from any ex-hazardous areas immediately.
Measures must be taken to prevent any accidental restarting of the device.
The safety of the device may be compromised, if for example:
Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
Markings or labels on the device are illegible.
We recommend that a device displaying errors or in which an error is suspected be sent back
to i.safe MOBILE GmbH to be checked.
EX-RELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety regulations and
has read and understood manual, safety instructions and certificate.
The following safety regulations must also be complied with:
Inside ex-hazardous areas the covers of all interfaces must be closed.
To ensure the IP-protection, it has to be ensured that the all gaskets are present and functional.
IP protection is not guaranteed anymore if gaps are visible.
The device may only be charged outside ex-hazardous areas using the i.safe PROTECTOR 2.0
or i.safe PROTECTOR 3.0 USB-cable or other equipment approved by i.safe MOBILE GmbH.
Physical connections to other equipment are only allowed outside ex-hazardous areas using
the i.safe PROTECTOR 2.0 or i.safe PROTECTOR 3.0 USB-cable or other equipment approved
by i.safe MOBILE GmbH.
The device may be charged only at ambient temperatures in between +5°C ... +35°C.
The device must not be exposed to abrasive acids or bases.
The device must not be taken into zones 0 or 20.
The device shall be protected from impacts with high impact energy and against excessive
UV light emission and high electrostatic charge processes.
Opening the interface covers in explosive atmospheres is not permitted.
EX-RELEVANT SAFETY REGULATIONS FOR NORTH AMERICA
Conditions of Acceptability:
The battery may be charged outside explosion hazardous areas only using approved external
adapter model ICP12-050-2000B with output rated 5Vdc, 2A or other external approved AC/DC
adapter which also complies with the requirements of LPS and has output rated 5Vdc, 2A.
Physical connections to other equipment are only allowed outside ex-hazardous areas.
Opening of any interface or connector covers in explosive atmosphere is not permitted.
EN 5