GreenWorks 5301002CO5301002CO Manual Del Propietário página 4

slot.
■ Place a flat head screwdriver (not included) in the
1/4 in. quick-connect plug. The slot in the top of
the filter will cause it to turn so it can be lifted out.
■ Once the filter is removed from the quick-connect
plug, replace it with a new filter (not included) or
clean as necessary by back flushing.
■ Using a flat head screwdriver, place the cleaned/
new inlet filter into the quick-connect plug and turn
the filter until it can no longer be seen over the top
of the inlet plug.
To reduce the risk of injury or property damage, spray
the pressure stream in a safe direction to ensure proper
connection of all accessories before starting any cleaning
project. Fits most pressure washers. Ensure compatibility
and proper fit before using this accessory. Do not use
if a part is broken or appears to be damaged. Wear
eye protection with side shields and goggles marked
to comply with ANSI Z87.1. Risk of fluid injections; do
not point at people, pets, electrical devices or the unit
itself. Turn off the pressure washer before changing or
adjusting accessories. For cold water use only. Save
these instructions. Refer to them frequently and use
them to instruct other users. If you loan someone this
tool, loan them these instructions also.
WARNING
4