Troubleshooting - Martin Yale Industries 62001 Manual De Instrucciones

6.2 Feed belts
Approximately once for every twenty hours of machine operation, clean the feed
belts of the unit with soap and water. Turn the machine off and on repeatedly to make
sure that the entire lengths of the belts are cleaned.
6.3 Holdback wheel maintenance
The holdback wheel does not rotate; hence it will wear a flat spot over time. If this
occurs, simply loosen the center screw of the holdback wheel and rotate it to expose a
fresh surface.
6.4 Blade Maintenance
For each 40,000 pieces of mail processed, coat both the upper and lower blades
with a blade emollient such as Premier Brand Trim Ease Lubricant (Martin Yale
#MRS037046, available through your Martin Yale Dealer).
7.0

Troubleshooting

Several of the most commonly encountered problems are listed below along with the
most common causes and remedies.
Problem
7.1 Envelopes Jam
7.2 Feeding
Problems
7.3 Envelopes
Only Partially
Cut
7.4 Envelope
Contents Cut
Possible Cause
Scrap build-up in ski assem-
bly and blade assembly area
Scrap bin filled beyond
capacity
Feed belts dirty
Holdback wheel worn
Envelope too thick
Transport Wheel not rotating
Ski Assembly misadjusted
Cut adjusted to wide
Envelopes not tamped
Remedy
Clean as outlined in section 6.1
Clear scrap out of letter opener and
make sure the scrap bin is cleared regu-
larly during machine use
Clean as described in section 6.2
Turn holdback wheel as described in
section 6.3
Make sure letter thickness is no more
than 1/4"
Verify that transport wheel spins as the
opener runs
Make sure ski assembly moves freely,
and the springs are still attached to both
ends of it.
Set the cut width adjustment to a nar-
rower setting
Prepare mail as outlined in section 5.2
6