Messages / Malfunctions / Errors - Microlife PF 100 Manual De Instrucciones

3. Insert paper into the printer by following the
instructions supplied with the printer.
4. Switch the printer on by moving the start
button to the «I» position.
5. Press the ON/OFF button to turn the Asthma
monitor on.
6. Print a Single Result
Select the memory value that you wish to print using by the «<»or «>» buttons.
Press the small switch next to the printer symbol on the data compartment. «Pr
1» is displayed and the printer starts printing.
• Print all Memory Data
Please follow the above instructions but press on the small switch next to the
printer symbol for about 3 seconds. «Pr» is displayed and the printer starts
printing all data.
10. Analyse Data by Computer
The monitor can be connected via a USB connection port with a computer and all
memory data can be analysed by the Microlife Asthma Monitor software program.
Please contact your Microlife dealer.

11. Messages / Malfunctions / Errors

If an error occurs one of the following listed error codes is displayed.
Message Cause
Er2 Data communication between device
and printer does not work.
no There is no data stored in the
Monitor.
Hi The result is higher than 900 ml/min. This is a very good result.
12
Remedy
Please check the cable
connection between device
and printer.