Tristar ConnaBride KB-7240 Manual De Instrucciones página 7

A damaged cord or plug must be replaced by an authorized technician to
•
avoid a hazard. Do not repair the device yourself,.
Under no circumstances must the device be placed in water or other liquid,
•
or come into contact with such. Do not use the device with wet or moist
hands.
Should the device become moist or wet, remove the mains plug from the
•
socket immediately. Do not reach into the water.
Use the device only for the intended purpose.
•
User tips
Your coolbox is able to keep your pre-cooled food and drinks refreshingly cool
with very little power requirement. When using the box for only a short time, place
only pre-cooled items into the box. At an outside temperature of approx. 25
the inside of the box will have the ideal cooling temperature of 8
2 hours operation. Thanks to the foam insulation, the food and drinks inside the
box will remain fresh for a long time, even without electric power for cooling.
Ensure that the box is placed in a position where the air from the external fan is
free to circulate. Do not place the box in direct sunlight.
Installation of the appliance
Install the appliance on a firm, horizontal surface. Avoid installing the appliance in
direct sunlight or near any source of heat.
The distance between the rear of the appliance and a wall shall not be less than
10 cm, and the minimum ventilating space from the sides of the appliance shall
never be less than 5 cm.
In all cases, the location shall be protected from rain and splashing.
To guarantee a good level of air circulation, do not obstruct the ventilation
grids of the upper of the appliance.
Even little children should not sit or stand on the appliance: the appliance
will be damaged as the balance of the fan will be disturbed.
Complying with the above will ensure efficient and economical cooling.
Before the first use of the appliance, clean the inside and the cover of the
appliance with warm water, adding detergent if necessary. Never use an abrasive
product.
Operation with a battery (12V DC)
60W – 3,5 amps. It is not necessary to check the polarity when starting up the
appliance.
Check that the battery voltage corresponds to the operating voltage of the
refrigerator, as marked on the corresponding the label. When the battery used is a
car battery, only switch the refrigerator on while the car is traveling/the engine is
running. If the refrigerator is left running when the car is stopped, this could
discharge the battery and it may be impossible to restart the engine.
V10.01
Operation with power socket)
60 W - 220-240V ~ 0.45A
Never use more energy sources at the same time.
Check if the socket power is the same as the power on the label before
connecting the plug into the socket.
Start-up
Plug the connector supplied with the refrigerator into the cigar lighter socket of the
vehicle or the power socket.
Disconnection of the appliance
Unplug the connector from the cigar lighter socket or the power socket.
o
C
o
C after approx. Storing food
Liquids to be stored in the refrigerator shall always be placed in a closed vessel.
The air circulation inside the appliance must not be obstructed.
Never place hot food or drink in the appliance.
Never keep flammable liquids and/or gases inside the refrigerator. Danger
of explosion.
Defrosting – Measures to be taken if the appliance is to be left unused for a
long period
The refrigerator must be defrosted regularly, in order to ensure that it operates
correctly.
If the appliance is to remain unused for a extensive period, disconnect it and
remove all food outside. Clean and dry the inside of the appliance.
In order to prevent unpleasant odor, leave the cover of the refrigerator slightly
open.
Maintenance
Clean the appliance regularly with warm water, containing a detergent if
necessary.
Never use an abrasive product. Dry the cleaned surfaces with a soft cloth. Use
only clear water to clean the seal of the cover, and then coat the seal with talcum
powder.
All repairs, particularly of the cooling unit, must mandatorily be carried out by a
qualified technician.
Service
If a problem occurs, carry out the following checks:
− Is the appliance installed in a horizontal position?
− Is there sufficient ventilation?
− For battery operation, check the battery and the connection.
12 V10.01 13