edenox 80403 Manual De Uso Y Mantenimiento página 15

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

GB
INSTALLATION
Comply with the safety recommendations indicated above and hereafter when installing the
appliance.
1.
Make sure that the mains voltage is as indicated on the rating label of the appliance and that
the electric system is grounded and equipped with a differential switch.
Install the appliance in a DRY, PROTECTED place, far from water sprays or splashes, heat
2.
sources, open flames and inflammable substances.
Place the blender on a flat, horizontal, stable surface where it cannot tip over.
3.
Make sure the switch on the appliance is in the "OFF" position and plug it into a socket
protected by a magneto thermal switch or fuses.
Do not use a multiple outlet plug.
Stretch the power cable out to full length. Do not let it pass over sharp edges or hot surfaces.
4.
Do not let oil spill on it. Do not let the power cable hang loose from the counter on which the
blender stands.
USE
1
Place the ingredients in the container in this order: first liquids and fruit, then ice and other solid
foods.
2
Stand the container on the base fitting it into its support as shown in figure 3.
3
Fit the lid on the container so that the magnetic sensor is in contact with the end of the safety
arm.
Note: When new, the lid of blender may require extra force to apply and remove. After a few
times it will fit perfectly.
Any attempt to by-pass the safety device and use the blender without its lid may cause
personal injury and/or damage to the appliance.
4
Select the desired speed and, holding one hand on the lid, select ON/OFF/PULSE switch to
"ON" - Fig. 4.
5
Most drinks require blending at high speed. Turn the switch to "LOW" only when preparing
small quantities or when using the blender just to mix the ingredients.
6
You can use the "PULSE" function by pressing the ON key part way when preparing dense
drinks that tend to "float" or to break up nuts or other ingredients that are unable to circulate in
the working zone of the blades.
7
The blender is also designed to crush ice and prepare FROZEN DRINKS from ice in cubes.
Remember that if you place the ice in the container already crushed this will greatly extend the
life of the appliance.
15

Publicidad

Tabla de contenido
loading

Tabla de contenido