Fcc Caution - Cystereo FUSION 2 Manual Del Usuario

EN
Reset
When your mobile phone can't be paired with the earbuds, place two
earbuds into the Charging Case, then simultaneously touch and hold the
Touchpad of two earbuds for 5 seconds until the LED Indicators are off for
1 second, which indicates the earbuds have been reset successfully.
Specification
Power Supply
BT Version
Frequency Range
Transmit Power (EIRP)
Battery Capacity of the Charging Case
Charging Time for the Earbud
Charging Time for the Charging Case
Playtime
11
11
5V 0.5A
V5.0
2402~2480MHz
<8dBm (for CE)
400mAh
1 Hour
1.5-2 Hours
Up to 8 Hours （ with 50% volume）

FCC Caution

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE：
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
FCC ID： 2AQ3A-FUSION2
ISEDC Warning
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of the
device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
EN
12
12