Uline H-7249 Manual Del Usuario página 2

GETTING STARTED
(SEE FIGURE 1)
1. Make sure the power switch is in the off position
(down).
2. Insert the AC power cord into the power supply.
3. Plug the other end of the cord into an appropriate
AC electrical outlet.
NOTE: The active power light will go on if power
is on at the AC outlet.
Figure 1
Power Receptacle
LOADING THE PRINTER
1. Open the printer. Pull the release latch levers toward
the front of the printer. (See Figure 2)
2. Open the media roll holders. Pull the media guides
open with your free hand and place the media roll
on the roll holders and release the guides.
3. Orient the media roll so that its printing surface will
face up as it passes over the platen roller.
PAGE 2 OF 18
ASSEMBLY
4. Insert the power supply's power connector into the
printer's power receptacle.
Printer
Plug (Varies by Country)
Power Switch
Power Connector
Active Power Light
Media Roll Holders
Release Latch Levers
Platen Roller
NOTE: Ensure the appropriate power cord with
a three (3) prong plug and an IEC 60320-C13
connector are used at all times. These power
cords must bear the relevant certification mark
of the country in which the product is being used.
Power Supply
IEC 60320-C13
Figure 2
Media Roll
AC Power Cord
0418 IH-7249