Uline H-7249 Manual Del Usuario página 4

LOADING RIBBON
1. With the printer open, place a new roll of ribbon on
ribbon supply spindles. (See Figure 5)
2. Rotate the roll until the notches align and lock into
the left side of the supply hub. (See Figure 5)
3. Place an empty ribbon core on the take-up spindles.
Rotate the ribbon core until the notches align and
lock into the left side of the take-up hub.
(See Figure 6)
4. The first ribbon take-up core is located in the
packing box. Subsequently, use the empty supply
core to take up the replacement roll of ribbon.
5. Pull the transfer ribbon's leader off the roll and
attach it with the adhesive strip on the leader to the
empty ribbon core on the take-up spindle.
(See Figure 7)
6. Center the ribbon on the ribbon core. (See Figure 7)
PAGE 4 OF 18
ASSEMBLY CONTINUED
Figure 5
Ribbon Supply Spindles
Figure 6
Take-Up Spindles
Figure 7
Adhesive Strip
0418 IH-7249