RIB MASTER Wi-Fi Manual De Instrucciones página 17

POINT D
- IDENTIFICATION
Each RED is supplied with microswitches in the OFF position to prevent batteries
from becoming discharged when not in use (if connected).
Each RED must be ABSOLUTELY unequivocally identified by putting only one of
the six microswitches in the ON position (SW2).
Only one of the six microswitches must be in the ON position and the identification
must be different for each RED.
Note: IDENTIFY RED CONTAINERS BY APPLYING NUMBERED ADHESIVE
LABEL (SUPPLIED WITH MASTER) ON OUTSIDE OF EACH CONTAINER.
Identification of containers serves to rapidly replace dead batteries in RED
indicated by EDGE LED on MASTER Wi-Fi or MASTER NO TOUCH 868 card.
EXAMPLE OF IDENTIFICATION OF 1 RED
ON A MASTER Wi-Fi or MASTER NO TOUCH 868
6
5
4
3
2
ON
1
MASTER Wi-Fi
MASTER NO TOUCH 868
POINT E
- SETTING AND VERIFY
SETTING UP RED TRANSMITTER LIKE PEDESTRIAN DOOR SECURITY ON
MASTER NO TOUCH 868
It is possible to set security for the pedestrian door only if you have already
programmed the NO TOUCH 868 photocell.
RED transmitter monitors a NC contact (not supplied) installed on the pedestrian
door on the main door.
To run the set up perform the following procedure:
- position the dip switch n° 2 to ON (COMPULSORY);
- supply the RED transmitter through the batteries;
- press the S1 PROG. RX pushbutton which is found on the MASTER NO TOUCH
868: the bi-colour LED DL1 will turn green and flash for 1 minute (time used
to run set up)
- press the S2 PROG. TX pushbutton the RED transmitter: on the MASTER NO
TOUCH 868 the bi-colour LED DL1 will stop flashing green and turn off . The
buzzer will emit a tone signalling while the red LED of the RED transmitter flashes
3 times to confirm the correct set up.
EXAMPLE OF IDENTIFICATION OF 3 RED
ON A MASTER Wi-Fi or MASTER NO TOUCH 868
6
5
4
3
2
1
MASTER Wi-Fi
RED 1
MASTER NO TOUCH 868
1 2
1 2
6
5
4
3
2
ON
1
RED 1
VERIFY THE CORRECT OPERATION OF THE PEDESTRIAN DOOR
SECURITY
Open the pedestrian door, opening NC contact connected to the RED transmitter.
Verify that on the MASTER NO TOUCH 868 the LEDs DL3 and DL4 turn off and
that any door opening command is not performed.
17
OFF
3 4 5 6
ON
3 4 5 6
6 6
5 5
4 4
3 3
2 2
1 1
RED 2 RED 3
G
B
6
5
4
3
2
1