Publicidad
Publicidad
Tabla de contenido
Manuales relacionados para Teltonika TRB141
Resumen de contenidos para Teltonika TRB141
- Página 1 Quick Start Guide v1.2...
-
Página 2: Front View
FRONT VIEW Power socket Input/output connector Power LED BACK VIEW Mobile signal strength indication LEDs Mobile network type LEDs Reset button USB port Mobile antenna connector... -
Página 3: Hardware Installation
DI1 and DI2 are DRY/WET configurable inputs. INPUT/OUTPUT CONNECTOR PINOUT WET: 0-1.9 V is detected as logical "0", 1.9-3.8 V is detected as logical "1". DRY: Logical "0" is detected when input is shorted to GND, otherwise input is detected as logical "1". NC*, C* and NO* are respectively Normally Closed, Common and Normally Open contacts of internal Relays 1 and 2. -
Página 4: Device Configuration
DEVICE CONFIGURATION 1. Power on the device and connect the USB cable to your computer. 2. Allow the gateway to boot up. This might take up to 30 seconds. 3. Your computer's OS should detect the USB device and install the driver. 4. -
Página 5: Safety Information
SAFETY INFORMATION TRB141 gateway must be used in compliance with any and all applicable national and international laws and with any special restrictions regulating the utilization of the communication module in prescribed applications and environments. Hereby, TELTONIKA declares that this TRB141 is in compliance with the essential requirements and other relevant provisions of [EN] English Directive RED. - Página 6 [SE] Instruktionsmanual: Anslut nätadap tern för att slå på enheten. Öppna 192.168.2.1 i en webbläsare för att konfigurera produkten. Mer information på www.teltonika-networks.com [SI] Navodila: Priključite napajalnik za vklop naprave. Odprite 192.168.2.1 v spletnem brskalniku nastaviti izdelek. Več informacij v www.teltonika-networks.com [SK] NávoZd na použitie: Pripojte napájací adaptér k zapnutiu prístroja. Otvorte 192.168.2.1 vo webovom prehliadači pre konfiguráciu produktu. Viac informácií...