Hart SAFETY GRIP RAIL Instrucciones De Instalación página 3

Installing the SAFETY GRIP RAIL assembly onto the bed:
INSTALLER QUICK TIP: You will find the installation easier if you remove the mattress.
SAFETY GRIP RAIL
Low Profile
Installed on bed
base/bed frame
Note: Mattress
to be added
8. Slide the assembled SAFETY GRIP RAIL between the mattress and the bed base or bed frame support.
SAFETY GRIP RAIL
Low Profile
9. Run the Long Webbing (part 111) across the base/bed frame and underneath, back to the SAFETY GRIP RAIL.
10. Feed the Long Webbing (part 111) through the buckle (part 107) at the desired length. Close the buckle (part 107) to secure the strap.
Repeat on other side.
11. Put the mattress back on the bed if you removed it.
12. Lie on the bed and position the SAFETY GRIP RAIL where it is most comfortable for you.
13. Tighten the two webbing straps securely against the base or bed frame, ensuring that the webbing straps are straight and parallel.
14. Loop and double tie the loose end of the Long Webbing (part 111) directly underneath the buckle (part 107). Cut off the excess webbing
of Long Webbing (part 111) to prevent tripping hazards.
SAFETY GRIP RAIL
Low Profile
Installed with
Mattress
SAFETY GRIP RAIL
Installation Instructions
107
111
SAFETY GRIP RAIL
High Profile
Installed on bed
base/bed frame
Note: Mattress
to be added
SAFETY GRIP RAIL
High Profile
111
SAFETY GRIP RAIL
High Profile
Installed with
Mattress
107
3