Door Reversal / Pannelling Instructions; Building-In The Appliance - KÜPPERBUSCH UKE 145-4 Manual De Usuario

Door reversal / Panelling instructions
Door reversal
1. Remove bottom hinge (4).
2. Remove door (3).
3. Remove pivot (1) from the top hinge and refit it in
the outer hole of the hinge on the opposite side.
4. Refit the door and the bottom hinge.
5. Remove handle (2) and refit it on the opposite
side.
D144

Building-in the appliance

Refer to the figure for required dimensions.
D145
B
A
1
2
3
4
Panelling the door
1. Take off the door frame section opposite to the
door handle.
2. Loosen, without removing them, all remaining
screws securing the door frame.
3. Slide in the decor panel from the frameless side,
then fasten again the frame to the door including
the previously removed frame section.
Panel dimensions
Width 488 mm
Height 681 mm
Max. thickness 4 mm
Supplied with the appliance is a kit including a
venting grille (Fig. -B) and two brackets (Fig. -A) to
fix the appliance to the kitchen unit.
1. Fit the two brackets on the upper hinges (see
detail, Fig.) and fix them by means of the screws
supplied with the kit.
2. Insert the appliance into the kitchen unit recess
and fix the two brackets to the unit by means of
two woodscrews.
3. Push-fit the front venting grille (B) in its housing.
D144
B
A
1
2
3
4
15