LUND I-20255 Manual De Instrucciones página 2

LIGHT BAR INSTALLATION:
1. Remove light bar from box and screw bolts and washers into each end.
2. Slide bolts into crossbeam brackets with the washers on the outside of the bracket, and tighten using
the supplied allen key.
BULL BAR INSTALLATION:
1. Start installation at the driver side, front of the vehicle. Remove the driver side tow hook, (Figure 1).
Fig 1
2. Select the driver side Frame Bracket, (Figure 2). Check the fit between the tow hook and the Bracket
for reinstallation over the Bracket. NOTE: Some factory tow hooks may not clear the Bracket and
cannot be reinstalled. Check for fit before bolting tow hook and Bracket in place.
(Fig 2) Driver/left Frame Mounting Bracket
Remove (2) factory hex
bolts to remove tow hook
Front
Front
Page 2 of 4
I-Sheet Number I-20255 Rev.A
REVOLUTION BULL BAR
07-16 TOYOTA TUNDRA
01/20/17