2
2.
Install Door Trim (A) onto door panel by aligning plastic
push pins on door trim (A) and pushing into place.
3.
Install 2 Phillips screws - long (D) through upper holes
in door trim panel (A). Tighten with phillips screwdriver.
4.
Install 1 Phillips screws - short (C) through lower holes
in door trim panel (A). Tighten with phillips screwdriver.
5.
Insert Window Grommet (E) into the forward most hole
in the door trim panel (A) and door.
6.
Insert Window Grommet (F) into the rear most hole
in the door trim panel (A) and door.
NOTE: Repeat all steps for passenger side.
02/09/2010
A
A
F
A
C
D
E
K6860949