Publicidad
Idiomas disponibles
Idiomas disponibles
Halogen floodlight projector on a tripod
Read this manual carefully before using this product and check whether there are any damaged parts. The
product has not to be installed in case of damages. Keep this product out of reach of children or any
unauthorized persons. At the end of its lifetime, please dispose of the product correctly. Electronic
components have to be disposed of as no standard landfill.
The packaging includes:
!
Tripod, extendable in two steps
!
Halogen floodlight projector 500W 2x for reference no. 008221
!
Suitable bulb
How to use the halogen floodlight projector
Installation of the bulb
1. Make sure that the projector is not connected to the power network.
2. Remove the upper screw from the projector's casing and remove the front glass.
3. Take the bulb out of its packaging. Do not touch the bulb with your bare hand. Use a towel to fix the bulb
into the fitting. First press one side of the fitting against the metal pin and shift the pin backwards so
that you can press the other side of the bulb against the metal pin.
4. After changing the light bulb, please pay attention to the correct positioning of the seal.
5. Fix the front glass with the screw.
Installation of the projector on the tripod
1. Fix the halogen floodlight projector with the screws to the horizontal pipe (tripod with two projectors) or
to the upper end of the tripod (tripod with one projector).
2. For the tripod with two projectors, fix the horizontal pipe with the two projectors to the upper part of the
tripod with a clamping screw. With this screw, you can easily adjust the projector horizontally.
Adjustments
1. The angle of inclination can be adjusted with the screw fixed on the side of the pipe. The angle of
inclination to the front is limited to 6° for safety reasons.
2. The length of the pipes of the tripod can be smoothly adjusted according to one's requirements. After
choosing the required radius, Fix the pipe with the clamping screw. The higher the radius the higher the
stability of the tripod.
3. The height of the tripod can be chosen according to one's requirements. This can be by a telescopic
mechanism. Open the clamping nuts and put the telescopic pipe into the required position.
Do not forget to fix the clamping nuts.
A.
B.
Assembling instruction
min. 95°
C.
1.
2.
max. 175°
GB
Publicidad
