Publicidad
Idiomas disponibles
Idiomas disponibles
COMPONENTS
1
castors
2
lifting rolls
3
pedal
4
pedal locking
5
release mechanism
6
safety Pin
INSTRUCTIONS
Lift
1. Press down the pedal to release its locking mechanism.
2. Pull the locking bolt out of its frame.
3. Open the release mechanism by turning the hand wheel counter-
clockwise.
4. Expand the jack far enough to fit it under your vehicle's tire.
Position it under the tire so that both lifting rolls touch the tire's
running surface.
5. Put on the jack so that the unit is parallel to the side of the tire you wish to lift.
6. Close the release mechanism by turning the hand wheel clockwise until it fits firmly. Leave some
space between tire and jack. This is very important. In case of a poorly positioned jack, the tire
might press against the jack's axle and not against its rolls which might cause damage to the jack
7. To lift the tire, put one foot on the pedal and push it gently and steadily downwards until the tire
has been lifted off the ground a couple of centimeters. The jack has a firmer stand as lower the
lifting height of the tire actually is.
8. Secure the jack by safety pin.
9. Repeat the procedure with the other units
10. Move the lifted vehicle as desired.
Release the jack
1. To release the jack, pull the jack's locking bolt out of its frame.
2. Open the release mechanism by turning the hand wheel counter-clockwise.
3. The jack can be removed as soon as the tire loses contact with the jack's rolls.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
1
2
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
6
3
4
5
Publicidad
