Lenz rcB 1200 Indicaciones De Seguridad página 78

OPERATING INSTRUCTIONS / ENGLISH
IMPORTANT INSTRUCTIONS FOR USE
When using the heated product, the optimal heating power is only produced when all heated
￭
products, textiles and socks you are wearing are dry.
Do not operate the device at the highest heating power for longer than several minutes.
￭
Always set the product to a low or medium heat output to maintain a comfortably warm
￭
temperature (the heater should be virtually unnoticeable).
FUNCTIONAL DESCRIPTION
lithium pack rcB 1200 / lithium pack rcB 1800
The lithium packs have three operating modes: POWER OFF – STANDBY – IN USE. They are
indicated with the heat setting display (Fig. 1.2) on the lithium packs and the remote control. The
number of illuminated LEDs corresponds to the selected heat setting.
POWER OFF:
The lithium packs are completely turned off and the heat setting display (Fig. 1.2) is permanently off.
￭
They can only be switched on with the control button (Fig. 1.3) of the lithium packs.
￭
Note:
The lithium packs cannot be switched to the POWER OFF mode manually!
If there is no heatable textile or charger connected to the lithium packs, the lithium packs
automatically switch to the POWER OFF mode after 12 hours!
(If you are using the Lenz heat app* to control your lithium packs remotely, the app must also be
closed on your smartphone in order for the lithium packs to be able to successfully switch to the
POWER OFF mode.)
IN USE:
The lithium packs supply the connected heatable textile with power.
￭
STANDBY:
The heat setting display (Fig. 1.2) flashes briefly at an interval of 2.5 seconds.
￭
he lithium packs are in stand-by and can be activated with the control button of the lithium packs
￭
(Fig. 1.3), or via the Lenz heat app* (Smartphone).
– 150 –
USE AND FUNCTION
Turn on the product to the lowest heat setting by briefly pushing the control button (approximately
0.5 seconds) on the lithium pack (Fig. 1.3).
Push the control key repeatedly to switch to the next higher setting and back to standby mode
after level 3.
The respective heat setting is indicated by the illumination of the heat setting display (Fig. 1.2) on
the lithium pack.
LED, flashing – standby (no heating power)
LED, steady on – low heating power
LEDs, steady on – meduim heating power
LEDs, steady on – high heating power
REMOTE CONTROL
The lithium packs rcB 1200 / lithium packs rcB 1800 can be controlled via the Lenz heat app* for
smartphones. The lithium packs must be in "Pairing Mode" to be able to couple them properly with
the smartphone.
Pairing Mode
Please switch the desired lithium packs to "Pairing Mode". For this purpose, push the control
button (Fig. 1.3.) for approx. 10 seconds until the heat setting displays (Fig. 1.2.) are blinking and
then immediately release the control button. The heat setting display in the middle is flashing
constantly.
LED, steady on – Pairing Mode
Note: The Pairing Mode remains active for 2 minutes! If no pairing takes place during this
time, this mode will end automatically!
*The optional Lenz heat app for convenient control is available for download via the
Android Play Store and the Apple Store.
– 151 –